The Confident Journal: Refashioning: Dolce and Gabbana Inspired - Red Lace Blouse (Plus: How to Fix Snags!)

By now you should know that I love Dolce and Gabbana and get a lot of my inspiration from this designer house. Today, I will show you how to update a red lace blouse to look similar to the D&G ones below.

So here is the blouse I found. It was on a dollar rack, so. . .again. . .I thought it was worth a dollar to see if I could refashion it. Notice how long the sleeves are and how they bell out. That's not my style at all! (No judgement if it's yours, though!)

Okay, before I get to how to fix it, I need to address how to get rid of snags. See the one in the picture below? This poor shirt was covered.

This is an old trick my mom taught me years ago. Find a needle threader. They usually come in those little travel sewing kits, but you can also find them in the sewing notions section of fabric stores.

So, what you do is you push the tip of the threader through the base of wherever your snag is. Make sure you poke it through very close and in front of the snag.

Then, with your finger, guide the snag into the loop of the threader.

Lastly, pull the snag through to the other side. Done! Good as new!

You can't even tell where it used to be. (I know you THINK you can tell, but that's actually the seam you are looking at. The snag in question is a tad farther to the right of the seam.)

Okay, so now that all your snags are fixed, let's get to altering this blouse! Look how long the sleeves are! (Sorry, no full body picture. I was in pajamas with no makeup.)

I cut the sleeves out and look what the armpits did! They jutted out at both sides.

So, I pinned them.

When I pinned them down, I noticed that the top of the shoulders started to gap, so I pinned those too and sewed every down.

Next, the sleeves.

I used the sleeve of a shirt I knew fit me as my pattern.

Then, I cut about an inch or two off the top of the sleeve. I just free-handed the curve because I've done this a million times.

Okay, really important: When you attach sleeves to a bodice, make sure to pin the halfway point at the top of the shoulder of. Then make that pin match the top of the shoulder of the bodice. Pin it. Pin the armpit seam of the sleeve to the armpit seam of the bodice. THEN pin the rest of the sleeve up. Always work at the two extremes before you pin the rest of the lengths and you'll be way less aggravated.